Skip to content

Arduino UNO R4 WiFi

Report component

Tell our team what needs attention. You must be signed in to send a report.

Up to 2,000 characters. Include what the team should check.

An Uno with Wi-Fi and a little built-in LED screen, so projects can go online and show simple messages.

UNO R4 (Renesas RA4M1, 5 V logic) plus an ESP32-S3 co-processor for Wi-Fi and Bluetooth LE, a 12x8 red LED matrix and a Qwiic I2C connector on a second bus. Same pins as the Uno. 6-24 V on VIN. Only 8 mA per GPIO.

Electrical

Supply voltage
6 to 24 V
Logic level
5 V
Talks over
digital, analog, pwm, i2c, spi, uart
Board
renesas-ra, 5 V logic, 60 mA total GPIO

Pins

PinCan doMax VMax mA
D0digital, serial RXSerial1 RX (USB is separate, so this pin is free). 8 mA max.5.58
D1digital, serial TXSerial1 TX.5.58
D2digital, interruptInterrupt pin.5.58
D3digital, PWM, interruptPWM, interrupt pin.5.58
D4digital5.58
D5digital, PWM5.58
D6digital, PWM5.58
D7digital5.58
D8digital5.58
D9digital, PWM5.58
D10digital, PWM, SPI selectSPI CS. CAN TX.5.58
D11digital, PWM, SPI MOSISPI COPI (MOSI).5.58
D12digital, SPI MISOSPI CIPO (MISO).5.58
D13digital, SPI clockSPI SCK. On-board LED. CAN RX.5.58
A0analog, digital, DACAnalog in, or 12-bit DAC output.5.58
A1analog, digitalAlso op-amp + input.5.58
A2analog, digitalAlso op-amp - input.5.58
A3analog, digitalAlso op-amp output.5.58
A4analog, digital, I2C dataI2C SDA (same bus as the SDA header pin).5.58
A5analog, digital, I2C clockI2C SCL (same bus as the SCL header pin).5.58
5V5 VRegulated 5 V.
3V33.3 V3.3 V rail.
VINpower in6-24 V input (same as the barrel jack).
GNDground
GND2ground
GND3ground
IOREFnot connectedLogic-level reference (5 V).
AREFnot connectedAnalog reference input.
RESETnot connectedPull LOW to reset.

Size and material

Size
69 × 15 × 53 mm
Material
pcb
Sold by the
piece

Projects using it

No public project uses it yet. Design one that does.