ESP32-CAM (AI-Thinker, OV2640) with USB programmer base
A tiny Wi-Fi camera board: takes pictures, streams video, and can recognise simple things.
ESP32 with 4 MB PSRAM, Wi-Fi/Bluetooth, a 2 MP OV2640 camera, microSD slot and a bright flash LED, on a 27 x 40.5 mm board. Streams video, takes photos and runs small vision models. Few free pins (most are shared with the camera and SD card). Needs a solid 5 V supply. Includes the ESP32-CAM-MB USB base for programming.
Electrical
- Supply voltage
- 4.75 to 5.25 V
- Logic level
- 3.3 V
- Current
- 180 mA typical, 500 mA max
- Talks over
- digital, analog, pwm, i2c, spi, uart
- Board
- esp32, 3.3 V logic, 1100 mA total GPIO
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| IO0 | not connectedCamera clock (XCLK). Tie to GND only to flash firmware. Not usable. | 3.6 | 20 |
| IO1 | digital, serial TXU0T: serial TX used for uploading and logs. | 3.6 | 20 |
| IO2 | digital, PWM, analog, boot pinmicroSD D0. Must be LOW or floating at boot. ADC2: not readable while Wi-Fi is on. | 3.6 | 20 |
| IO3 | digital, serial RXU0R: serial RX used for uploading. | 3.6 | 20 |
| IO4 | digital, PWM, analogDrives the white flash LED; microSD D1 in 4-bit mode. ADC2: not readable while Wi-Fi is on. | 3.6 | 20 |
| IO12 | digital, PWM, analog, boot pinmicroSD D2. Keep LOW at boot (sets flash voltage). ADC2: not readable while Wi-Fi is on. | 3.6 | 20 |
| IO13 | digital, PWM, analogmicroSD D3. Free in 1-bit SD mode. ADC2: not readable while Wi-Fi is on. | 3.6 | 20 |
| IO14 | digital, PWM, analog, I2C clockmicroSD CLK. Use as I2C SCL (Wire.begin(15, 14)) when the SD card is unused. ADC2: not readable while Wi-Fi is on. | 3.6 | 20 |
| IO15 | digital, PWM, analog, boot pin, I2C datamicroSD CMD. Use as I2C SDA when the SD card is unused. Outputs PWM at boot. ADC2: not readable while Wi-Fi is on. | 3.6 | 20 |
| IO16 | not connectedPSRAM chip select. Not usable. | 3.6 | 20 |
| 5V | 5 V, power inPower input, 5 V. Use a supply that can give 500 mA+ or the camera browns out. | ||
| 3V3 | 3.3 V3.3 V. Can power the board instead of 5V, but 5 V is more reliable. | ||
| VCC | not connected3.3 V or 5 V OUTPUT (set by a solder jumper). Not a power input. | ||
| GND | ground | ||
| GND2 | ground | ||
| GND3 | ground |
Size and material
- Size
- 27 × 5 × 41 mm
- Material
- pcb
- Sold by the
- piece
Projects using it
No public project uses it yet. Design one that does.