Skip to content

Water solenoid valve, 12 V, 1/2"

Report component

Tell our team what needs attention. You must be signed in to send a report.

Up to 2,000 characters. Include what the team should check.

An electric tap that lets water through when switched on, for irrigation and filling.

Normally closed plastic valve with 1/2" (NPS) inlets; opens while powered. 12 V at 320 mA (works down to 6 V). Needs 0.02-0.8 MPa of water pressure to seal and open properly, so it suits mains or pump pressure, not gravity feed. 84 x 43 x 57 mm.

Electrical

Supply voltage
6 to 12 V
Current
320 mA typical, 320 mA max

Needs alongside it

  • Switch it with a relay module or a logic-level MOSFET.
  • Put a 1N4007 across the coil (stripe to +) when switching it with a MOSFET.
  • Power from a battery or supply rated for 12 V 0.5 A, not the board's 5 V pin. Join the grounds.

Pins

PinCan doMax VMax mA
+not connected
-not connected

Size and material

Size
84 × 57 × 43 mm
Weight
122 g
Material
plastic
Sold by the
piece

Projects using it

No public project uses it yet. Design one that does.