ACS712 hall-effect current sensor module, ±20 A
Measures how much current a motor, heater or battery draws.
Allegro ACS712ELC-20A on a module: the load current flows through the screw terminals (isolated from the logic), output is VCC/2 at 0 A and 100 mV per amp, AC or DC. 5 V supply; output can reach 4.5 V. Size wiring and terminals for the current.
- Draws high current. Designs using it get a safety review before we build them.
Electrical
- Supply voltage
- 4.5 to 5.5 V
- Logic level
- 5 V
- Current
- 10 mA typical, 13 mA max
- Talks over
- analog
Needs alongside it
- OUT can reach 4.5 V: divide it down for a 3.3 V board's ADC.
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| VCC | 5 V | ||
| GND | ground | ||
| OUT | analog2.5 V at 0 A, 100 mV/A. | ||
| IP+ | not connectedLoad current in (screw terminal). | ||
| IP- | not connectedLoad current out (screw terminal). |
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
Projects using it
No public project uses it yet. Design one that does.