BTS7960 43 A H-bridge motor driver (IBT-2)
A heavy-duty driver for big motors like linear actuators, wipers and scooter motors.
Two Infineon BTS7960 half-bridges on a big heatsink: one DC motor at up to 43 A peak. Motor supply 6-27 V on screw terminals; logic VCC 5 V. Separate PWM for each direction (RPWM/LPWM) and enable pins. Current-sense outputs reach 5 V.
- Draws high current. Designs using it get a safety review before we build them.
Electrical
- Supply voltage
- 5 to 27 V
- Current
- 10000 mA typical, 43000 mA max
- Talks over
- digital, pwm
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| VCC | 5 VLogic, 5 V. | ||
| GND | ground | ||
| RPWM | PWMForward PWM. 3.3 V logic is marginal: use 5 V logic or a 74AHCT buffer. | ||
| LPWM | PWMReverse PWM. | ||
| R_EN | digitalHIGH to enable. | ||
| L_EN | digitalHIGH to enable. | ||
| R_IS | analogCurrent sense, up to 5 V: divide before a 3.3 V board. | ||
| L_IS | analogCurrent sense, up to 5 V. | ||
| B+ | power inMotor supply 6-27 V (screw terminal). Fuse it. | ||
| B- | groundMotor supply ground. | ||
| M+ | not connected | ||
| M- | not connected |
Size and material
- Size
- 50 × 43 × 50 mm
- Material
- metal
- Sold by the
- piece
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.