MCP2515 CAN bus module with TJA1050 transceiver
Lets the project listen to and talk on a car's or machine's CAN network.
SPI CAN 2.0B controller (MCP2515) plus TJA1050 transceiver, up to 1 Mb/s, 120 Ω termination jumper. Talks to vehicle, e-bike and industrial CAN networks. Needs 5 V (the TJA1050 is a 5 V part), so its SO/INT outputs are 5 V: shift them for 3.3 V boards. About 5 mA.
Electrical
- Supply voltage
- 4.75 to 5.25 V
- Logic level
- 5 V
- Current
- 5 mA typical, 5 mA max
- Talks over
- spi
Needs alongside it
- SO and INT are 5 V: use a level shifter on 3.3 V boards.
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| INT | digitalInterrupt output, active LOW. | ||
| SCK | SPI clock | ||
| SI | SPI MOSI | ||
| SO | SPI MISO5 V output. | ||
| CS | SPI select | ||
| GND | ground | ||
| VCC | 5 V | ||
| CANH | not connectedCAN high. | ||
| CANL | not connectedCAN low. |
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.