CAN bus transceiver (TJA1051T/3, CAN Pal)
Lets the project join a CAN network, the wiring that cars and machines use to talk.
Connects a board with a built-in CAN controller (ESP32 TWAI, UNO R4) to a CAN bus (cars, e-bikes, industrial). 3-5 V power and logic, built-in 5 V charge pump, switchable 120 Ω termination, terminal block for CANH / CANL / GND. Up to 5 Mbit/s (CAN FD).
Electrical
- Supply voltage
- 3 to 5.5 V
- Talks over
- digital
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| Vcc | 3.3 V, 5 VSame as the board's logic voltage. | ||
| GND | ground | ||
| TX | digitalFrom the board's CAN TX. | ||
| RX | digitalTo the board's CAN RX. | ||
| SLNT | digitalPull HIGH for silent (listen-only) mode. | ||
| CANH | not connectedCAN high. | ||
| CANL | not connectedCAN low. |
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.