DHT22 / AM2302 temperature + humidity module
Measures how warm and how humid the air is, about once every two seconds.
Aosong AM2302 on a 3-pin breakout with the 10 kΩ data pull-up fitted. -40 to 80 °C (±0.5 °C), 0-100 % RH (±2 %). One reading every 2 s over its own single-wire protocol. 3.3-6 V.
Electrical
- Supply voltage
- 3.3 to 6 V
- Current
- 1.5 mA typical, 2.5 mA max
- Talks over
- digital
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| VCC | 3.3 V, 5 VMarked +. Power it from the same voltage as the board's logic so DATA matches. | ||
| DATA | digitalMarked OUT. Single-wire protocol (not Dallas 1-Wire). Pull-up is on the module. | ||
| GND | groundMarked -. |
Size and material
- Size
- 15 × 8 × 25 mm
- Material
- plastic
- Sold by the
- piece
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.