DRV8825 stepper motor driver carrier (Pololu)
Drives a stepper motor smoothly with finer steps and higher voltage than the A4988.
Pololu-format bipolar stepper driver: STEP/DIR control, up to 1/32 microstepping, adjustable current limit. Motor supply VMOT 8.2-45 V, logic 2.5-5.25 V. 1.5 A per coil continuous without a heatsink, 2.2 A with cooling. Same pinout as the A4988 except FLT. 15.2 x 20.3 mm, 1.6 g. Needs 100 µF across VMOT.
Electrical
- Supply voltage
- 2.5 to 45 V
- Talks over
- digital
Needs alongside it
- VMOT needs an 8.2-45 V supply sized for the motor. Set the current limit before connecting the motor.
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| VMOT | power inMotor supply 8.2-45 V. 100 µF across VMOT/GND. | ||
| GND | groundMotor ground. | ||
| B2 | not connected | ||
| B1 | not connected | ||
| A1 | not connected | ||
| A2 | not connected | ||
| FLT | digitalFault output, LOW on over-current or over-temperature. | ||
| GND2 | groundLogic ground. | ||
| STEP | digitalOne pulse = one (micro)step. | ||
| DIR | digital | ||
| EN | digitalLOW = enabled (default). | ||
| SLP | digitalPull HIGH (or tie to RST) to run. | ||
| RST | digital | ||
| M0 | digitalMicrostep select. | ||
| M1 | digital | ||
| M2 | digital |
Size and material
- Size
- 15 × 3 × 20 mm
- Weight
- 1.6 g
- Material
- pcb
- Sold by the
- piece
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.