DRV8838 single motor driver carrier (Pololu)
A very small driver that runs one little motor forwards and backwards.
Tiny single H-bridge for one small DC motor: 0-11 V motor supply, 1.7 A continuous (1.8 A peak), logic 1.8-7 V, PWM up to 250 kHz, reverse-voltage protected. PHASE sets direction, ENABLE takes PWM. 10.2 x 12.7 mm, 0.3 g.
Electrical
- Supply voltage
- 1.8 to 11 V
- Talks over
- digital, pwm
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| VIN | power inMotor supply, 0-11 V (reverse protected). | ||
| VM | not connectedMotor supply after the protection MOSFET (output). | ||
| VCC | 3.3 V, 5 VLogic supply, 1.8-7 V. | ||
| GND | ground | ||
| OUT1 | not connected | ||
| OUT2 | not connected | ||
| PHASE | digitalDirection. | ||
| ENABLE | PWM, digitalPWM speed; HIGH drives the motor. | ||
| SLEEP | digitalPulled HIGH (running) on the board. |
Size and material
- Size
- 10 × 3 × 13 mm
- Weight
- 0.3 g
- Material
- pcb
- Sold by the
- piece
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.