Brushed ESC for RC boats/cars, 320 A, 6-12 V
Controls the speed and direction of a boat or car motor from a radio receiver or board.
Two-way (forward/reverse) speed controller for one brushed motor (540/550 class) from a 2-3S LiPo or 6-12 V pack, with a 5 V 2 A BEC that powers the receiver and servo. Takes a standard servo signal. The 320 A figure is a burst rating; size wiring for 20-30 A.
- Draws high current. Designs using it get a safety review before we build them.
Electrical
- Supply voltage
- 6 to 12.6 V
- Current
- 5000 mA typical, 30000 mA max
- Talks over
- pwm
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| BAT+ | power inRed battery lead. | ||
| BAT- | groundBlack battery lead. | ||
| M+ | not connectedTo the motor. Swap M+ and M- to reverse. | ||
| M- | not connected | ||
| SIG | PWMServo lead signal, 1-2 ms (1.5 ms = stop). | ||
| BEC+ | 5 V5 V out to the receiver/servo. | ||
| BEC- | ground |
Size and material
- Size
- 46 × 18 × 33 mm
- Material
- plastic
- Sold by the
- piece
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
