25D metal gearmotor 20.4:1 HP 12V with 48 CPR encoder (Pololu)
A strong geared motor with position feedback for bigger robots, carts and winches.
25 mm diameter Pololu gearmotor with a 48 CPR quadrature encoder (about 979 counts per output turn; encoder needs 3.5-20 V). 500 rpm no-load and 7.4 kg·cm stall at 12 V; 0.3 A no-load, 5 A stall. 25 mm x 65 mm, 4 mm D-shaft, 98 g, 20 cm leads. For mid-size robots, rovers and winches.
Electrical
- Supply voltage
- 6 to 12 V
- Logic level
- 5 V
- Current
- 300 mA typical, 5000 mA max
- Talks over
- digital
Needs alongside it
- Encoder outputs swing to its 5 V supply: divide or shift them on 3.3 V boards.
- Needs a driver good for 5 A stall at 12 V (MAX14870 for light loads, VNH5019 or a G2 for full stall).
- Power from a supply rated for 5 A per motor at 12 V, not the board's 5 V pin. Join the grounds.
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| M+ | not connectedRed motor lead. | ||
| M- | not connectedBlack motor lead. | ||
| ENC_VCC | 5 VBlue lead. Encoder supply 3.5-20 V: use 5 V. | ||
| ENC_GND | groundGreen lead. | ||
| ENC_A | digitalYellow lead. Swings 0 to ENC_VCC. | ||
| ENC_B | digitalWhite lead. Swings 0 to ENC_VCC. |
Size and material
- Size
- 25 × 65 × 25 mm
- Weight
- 98 g
- Material
- metal
- Sold by the
- piece
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.