GPS module NEO-6M (GY-NEO6MV2) with ceramic antenna
A low-cost GPS that tells the project where it is.
u-blox NEO-6M GPS on a breakout with EEPROM, backup battery and patch antenna: 22-satellite tracking, -162 dBm, about ±2.5 m accuracy in the open. UART at 9600 baud by default (4800-115200). 3.3-5 V supply, 67 mA running, 11 mA standby.
Electrical
- Supply voltage
- 3.3 to 5 V
- Current
- 67 mA typical, 67 mA max
- Talks over
- uart
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| VCC | 3.3 V, 5 V | ||
| RX | serial RXFrom the board's TX. | ||
| TX | serial TXTo the board's RX. | ||
| GND | ground |
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.