HX711 24-bit load cell amplifier
Reads the tiny signal from a load cell so the board can turn it into a weight.
Avia HX711 24-bit ADC with programmable gain (32/64/128) for bridge sensors, on an Adafruit breakout with a terminal block for one or two load cells. 10 or 80 samples/s. Two-wire clock/data interface (not I2C). 2.6-5.5 V, under 1.5 mA.
Electrical
- Supply voltage
- 2.6 to 5.5 V
- Current
- 1.5 mA typical, 1.5 mA max
- Talks over
- digital
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| VIN | 3.3 V, 5 V | ||
| GND | ground | ||
| DATA | digitalDOUT. Data ready when it goes LOW. | ||
| CLK | digitalPD_SCK. Holding it HIGH for over 60 µs powers the chip down. | ||
| E+ | not connectedLoad cell excitation +. | ||
| E- | not connectedLoad cell excitation -. | ||
| A- | not connectedChannel A input -. | ||
| A+ | not connectedChannel A input +. | ||
| B- | not connectedChannel B input - (second cell). | ||
| B+ | not connectedChannel B input + (second cell). |
Size and material
- Size
- 26 × 12 × 23 mm
- Weight
- 3.9 g
- Material
- pcb
- Sold by the
- piece
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.