INA219 current + voltage sensor (26 V, ±3.2 A)
Measures how much power a battery, solar panel or motor is using.
High-side power monitor with a 0.1 Ω shunt. Measures bus voltage up to 26 V and current up to ±3.2 A (0.8 mA resolution). I2C at 0x40 (0x41, 0x44, 0x45 by jumper). Sensor runs on 3-5 V.
Electrical
- Supply voltage
- 3 to 5.5 V
- Current
- 1 mA typical, 1 mA max
- Talks over
- i2c
- I2C address
- 0x40, 0x41, 0x44, 0x45
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| VCC | 3.3 V, 5 V | ||
| GND | ground | ||
| SCL | I2C clock | ||
| SDA | I2C data | ||
| Vin+ | not connectedFrom the supply being measured (up to 26 V). | ||
| Vin- | not connectedTo the load being measured. |
Size and material
- Size
- 26 × 5 × 20 mm
- Material
- pcb
- Sold by the
- piece
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.