High-power IR LED emitter board (2 LEDs, FET driver)
A strong infrared blaster for controlling TVs and air conditioners from across the room.
Two high-power IR LEDs with an onboard N-channel FET, so a 3-5 V logic signal switches them directly: about 200 mA per LED at 5 V (100 mA at 3 V). STEMMA JST-PH 3-pin connector.
Electrical
- Supply voltage
- 3 to 5.5 V
- Current
- 200 mA typical, 400 mA max
- Talks over
- digital, pwm
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| V+ | 3.3 V, 5 V | ||
| GND | ground | ||
| In | digital, PWMLogic input to the FET; 38 kHz carrier from the board. |
Size and material
- Size
- 25 × 7 × 18 mm
- Weight
- 1.8 g
- Material
- pcb
- Sold by the
- piece
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.