Micro limit switch with lever
A switch that clicks when something moving reaches the end, so a motor knows when to stop.
Snap-action micro switch with a flat metal lever and two terminals (normally open). Used as an end stop: a moving part presses the lever at the end of its travel.
Electrical
- Supply voltage
- 0 to 125 V
- Talks over
- digital
Needs alongside it
- Use the board's internal pull-up (INPUT_PULLUP). Pressed reads LOW.
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| 1 | digitalTerminal to a GPIO. | ||
| 2 | digital, groundTo GND. |
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.