Micro linear actuator 100 mm, 12 V, with position feedback (Glideforce GF01)
A slim electric push-rod that knows exactly how far out it is, for vents, lids and small lifts.
Small IP66 lead-screw actuator with a built-in potentiometer that reports position. 100 mm stroke (157 mm retracted, 257 mm extended), 8.1 kgf (80 N) dynamic load, 4 kgf static hold, 8.6 mm/s no-load. 12 V: 150 mA no-load, 250 mA at max load, 280 mA stall. 20 % duty cycle. No limit switches: stop it with the feedback. 59 g, 300 mm cable.
Electrical
- Supply voltage
- 6 to 12 V
- Current
- 150 mA typical, 280 mA max
- Talks over
- analog
Needs alongside it
- Use an H-bridge rated for 12 V (MAX14870 or TB6612FNG); stop it by reading the feedback, since it has no limit switches.
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| M+ | not connectedRed motor lead. | ||
| M- | not connectedBlack motor lead. Swap to retract. | ||
| POT+ | 3.3 V, 5 VFeedback potentiometer supply (board logic voltage). | ||
| POT_WIPER | analogPosition: voltage rises as it extends. | ||
| POT- | groundFeedback potentiometer ground. |
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.