Skip to content

LoRa radio RFM96W, 433 MHz (SX1276)

Report component

Tell our team what needs attention. You must be signed in to send a report.

Up to 2,000 characters. Include what the team should check.

A long-range radio for small messages, on the 433 MHz band.

The 433 MHz version of the LoRa breakout: +20 dBm, about 2 km line of sight, SPI, 3-5 V safe. Use where 433 MHz is the licence-free band (e.g. parts of Europe and Asia). Needs an antenna: solder a quarter-wave wire (8.2 cm at 915 MHz, 16.5 cm at 433 MHz) or a u.FL/SMA antenna.

Electrical

Supply voltage
3.3 to 6 V
Current
30 mA typical, 120 mA max
Talks over
spi

Pins

PinCan doMax VMax mA
VIN3.3 V, 5 V3.3-6 V in, regulated to 3.3 V. Needs 150 mA peaks while transmitting.
GNDground
ENdigitalRegulator enable, pulled high. Pull LOW to cut power to the radio.
SCKSPI clock
MISOSPI MISO3.3 V logic out.
MOSISPI MOSI
CSSPI select
RSTdigitalRadio reset.
G0digital, interruptIRQ to the board (3.3 V logic).
G1digitalRadio GPIO. Usually unused.
G2digitalRadio GPIO. Usually unused.
G3digitalRadio GPIO. Usually unused.
G4digitalRadio GPIO. Usually unused.
G5digitalRadio GPIO. Usually unused.

Size and material

Size
29 × 4 × 25 mm
Weight
3.1 g
Material
pcb
Sold by the
piece

Works with

Projects using it

No public project uses it yet. Design one that does.