IRF520 MOSFET switch module
A switch board that lets a pin turn a pump, LED strip or small motor on and off.
Low-side MOSFET board with screw terminals: switches a 0-24 V DC load up to 5 A (heatsink needed above 1 A) from a SIG pin. The IRF520 is not a logic-level part: at 5 V it switches small loads, but at 3.3 V it only partly turns on, so for ESP32/Pi use a logic-level MOSFET (IRLZ44N) or the dual D4184-type board.
Electrical
- Supply voltage
- 0 to 24 V
- Talks over
- digital, pwm
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| SIG | PWM, digitalGate signal from the board. | ||
| VCC | 5 V, 3.3 VNot needed for switching; leave unconnected or tie to logic supply. | ||
| GND | groundBoard ground. | ||
| VIN | power inLoad supply + in (0-24 V). | ||
| GND2 | groundLoad supply - (screw terminal marked GND). | ||
| V+ | not connectedTo the load +. | ||
| V- | not connectedTo the load -. |
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.