Pololu G2 high-power motor driver 18v17
A heavy-duty driver for one large motor, like a wheelchair, scooter or winch motor.
Single MOSFET H-bridge for big DC motors: 6.5-30 V, 17 A continuous, PWM to 100 kHz, 1.8-5.5 V logic, current sense (20 mV/A), adjustable current limit (VREF), reverse-voltage protection. DIR + PWM control, active-low SLP. 33 x 20.3 mm, 3.3 g.
- Draws high current. Designs using it get a safety review before we build them.
Electrical
- Supply voltage
- 1.8 to 30 V
- Current
- 17000 mA typical, 17000 mA max
- Talks over
- digital, pwm, analog
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| VIN | power inMotor supply 6.5-30 V (reverse protected). Fuse it. | ||
| VM | not connectedMotor supply after reverse protection (output). | ||
| GND | ground | ||
| OUTA | not connected | ||
| OUTB | not connected | ||
| DIR | digital | ||
| PWM | PWM | ||
| SLP | digitalPulled HIGH (enabled) on the board; drive LOW to sleep. | ||
| FLT | digitalOpen-drain fault output. | ||
| CS | analogCurrent sense, 20 mV per amp. | ||
| VREF | not connectedResistor to GND lowers the current limit. |
Size and material
- Size
- 33 × 5 × 20 mm
- Weight
- 3.3 g
- Material
- pcb
- Sold by the
- piece
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.