MPR121 12-key capacitive touch sensor
Turns up to twelve objects, like foil pads or fruit, into touch buttons.
NXP MPR121: 12 capacitive touch inputs (wire them to foil, fruit, paint or metal), interrupt on touch. I2C at 0x5A (0x5B-0x5D via ADDR), up to 48 pads per bus. 3.3-5 V.
Electrical
- Supply voltage
- 3.3 to 5 V
- Logic level
- 3.3 V
- Talks over
- i2c
- I2C address
- 0x5A, 0x5B, 0x5C, 0x5D
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| VIN | 3.3 V, 5 V3-5 V. Use the board's logic voltage. | ||
| 3Vo | 3.3 V3.3 V regulator output. Leave unconnected normally. | ||
| GND | ground | ||
| SCL | I2C clock | ||
| SDA | I2C data | ||
| INT | digitalInterrupt, LOW on a touch change. | ||
| ADDR | digitalAddress select. | ||
| 0 | not connectedTouch electrode 0. | ||
| 1 | not connectedTouch electrode 1. | ||
| 2 | not connectedTouch electrode 2. | ||
| 3 | not connectedTouch electrode 3. | ||
| 4 | not connectedTouch electrode 4. | ||
| 5 | not connectedTouch electrode 5. | ||
| 6 | not connectedTouch electrode 6. | ||
| 7 | not connectedTouch electrode 7. | ||
| 8 | not connectedTouch electrode 8. | ||
| 9 | not connectedTouch electrode 9. | ||
| 10 | not connectedTouch electrode 10. | ||
| 11 | not connectedTouch electrode 11. |
Size and material
- Size
- 33 × 5 × 19 mm
- Material
- pcb
- Sold by the
- piece
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.