Skip to content

MQ-2 smoke / combustible gas sensor module

Report component

Tell our team what needs attention. You must be signed in to send a report.

Up to 2,000 characters. Include what the team should check.

Smells smoke and flammable gas, for alerts and experiments. Not a certified smoke or gas alarm.

Hanwei MQ-2 tin-oxide sensor on an LM393 comparator board: responds to LPG, propane, methane, hydrogen and smoke. AO rises with concentration; DO goes LOW past the trimmer threshold. 5 V heater draws about 150 mA and the can runs warm; allow a 24-48 h burn-in and a few minutes of warm-up. Detects, doesn't identify, gas, and is not a certified alarm.

Electrical

Supply voltage
4.9 to 5.1 V
Logic level
5 V
Current
150 mA typical, 180 mA max
Talks over
analog, digital

Needs alongside it

  • AO and DO reach 5 V: divide them (10k/20k) on 3.3 V boards.

Pins

PinCan doMax VMax mA
VCC5 V
GNDground
DOdigitalLOW above the threshold; swings to 5 V.
AOanalogUp to 5 V.

Works with

Projects using it

No public project uses it yet. Design one that does.