PMSA003I particulate matter sensor (PM1/PM2.5/PM10, I2C)
Counts smoke and dust particles in the air, for wildfire smoke and workshop dust.
Plantower PMSA003I laser particle counter on an Adafruit breakout: PM1.0, PM2.5 and PM10 mass plus particle counts from 0.3 µm, 0-500 µg/m³ effective. I2C at 0x12. Board boosts to the 5 V the sensor needs; up to 100 mA active. Has a fan: give it airflow.
Electrical
- Supply voltage
- 3.3 to 5 V
- Logic level
- 3.3 V
- Current
- 100 mA typical, 100 mA max
- Talks over
- i2c
- I2C address
- 0x12
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| VIN | 3.3 V, 5 V3-5 V. Use the board's logic voltage. | ||
| 3Vo | 3.3 V3.3 V regulator output. Leave unconnected normally. | ||
| GND | ground | ||
| SCL | I2C clock | ||
| SDA | I2C data | ||
| RST | digitalReset. | ||
| SET | digitalLOW to sleep. |
Size and material
- Size
- 51 × 14 × 36 mm
- Weight
- 28 g
- Material
- metal
- Sold by the
- piece
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.