PowerBoost 1000C: LiPo charger + 5 V 1 A booster
Charges the project's battery and turns it into steady 5 V, so it runs plugged in or unplugged.
Load-sharing 1 A Li-ion charger (micro-USB) plus a TPS61090 boost to 5.2 V at 1 A+ from one cell, on one board: a complete USB power bank for a project that keeps running while it charges. Low-battery LED/pin at 3.2 V, EN pin. 23 x 45 x 10 mm with the USB-A jack.
- Charges lithium batteries. Designs using it get a safety review before we build them.
Electrical
- Supply voltage
- 4.5 to 5.5 V
- Current
- 500 mA typical, 2000 mA max
- Talks over
- power, digital
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| USB | 5 VMicro-USB 5 V charging input (not the output). | ||
| BAT | batteryBattery + (also on the JST-PH jack). | ||
| VS | not connectedLoad-sharing supply: USB when plugged in, else the battery. | ||
| 5V | not connected5.2 V boosted output to the project. | ||
| EN | digitalPull LOW to turn the boost off. | ||
| LBO | digitalGoes LOW when the battery drops below 3.2 V. | ||
| GND | ground |
Size and material
- Size
- 23 × 10 × 45 mm
- Weight
- 6 g
- Material
- pcb
- Sold by the
- piece
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.