Packet radio RFM69HCW, 868/915 MHz
A radio for sending small messages a few hundred metres, like a remote button or a sensor in the garden.
Simple, reliable FSK packet radio, +13 to +20 dBm, about 500 m line of sight. 50-150 mA while transmitting, ~30 mA listening. SPI, 3-5 V safe. Only talks to other RFM69 radios on the same band. Needs an antenna: solder a quarter-wave wire (8.2 cm at 915 MHz, 16.5 cm at 433 MHz) or a u.FL/SMA antenna.
Electrical
- Supply voltage
- 3.3 to 6 V
- Current
- 30 mA typical, 150 mA max
- Talks over
- spi
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| VIN | 3.3 V, 5 V3.3-6 V in, regulated to 3.3 V. Needs 150 mA peaks while transmitting. | ||
| GND | ground | ||
| EN | digitalRegulator enable, pulled high. Pull LOW to cut power to the radio. | ||
| SCK | SPI clock | ||
| MISO | SPI MISO3.3 V logic out. | ||
| MOSI | SPI MOSI | ||
| CS | SPI select | ||
| RST | digitalRadio reset. | ||
| G0 | digital, interruptIRQ to the board (3.3 V logic). | ||
| G1 | digitalRadio GPIO. Usually unused. | ||
| G2 | digitalRadio GPIO. Usually unused. | ||
| G3 | digitalRadio GPIO. Usually unused. | ||
| G4 | digitalRadio GPIO. Usually unused. | ||
| G5 | digitalRadio GPIO. Usually unused. |
Size and material
- Size
- 25 × 4 × 29 mm
- Weight
- 3.4 g
- Material
- pcb
- Sold by the
- piece
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.