Rain sensor (LM393 board + nickel plate)
Tells when it starts raining, so a cover can close or watering can stop.
Rain plate on a 2-wire lead to a comparator board. DO goes LOW when rain is detected (threshold set by the trimmer); AO gives the raw level. 3.3-5 V. Only the plate goes outside.
Electrical
- Supply voltage
- 3.3 to 5 V
- Talks over
- digital, analog
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| VCC | 3.3 V, 5 V | ||
| GND | ground | ||
| DO | digitalLOW when wet. Same voltage as VCC. | ||
| AO | analogRaw level. Lower = wetter. |
Size and material
- Size
- 54 × 2 × 40 mm
- Material
- pcb
- Sold by the
- piece
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.