FlySky FS-i6X 2.4 GHz transmitter + FS-iA6B receiver
The hand-held remote control and the little receiver that goes in the boat or car.
6-channel (10 with firmware) hand-held RC transmitter with a 6-channel receiver. Each channel outputs a servo signal that can drive a servo or ESC directly, or the board can read all channels over the i-BUS serial port. Receiver runs on 4.0-6.5 V (usually from the ESC's BEC). Transmitter takes 4 AA cells.
Electrical
- Supply voltage
- 4 to 6.5 V
- Current
- 40 mA typical, 60 mA max
- Talks over
- pwm, uart
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| CH1 | PWMUsually steering. | ||
| CH2 | PWMChannel 2 servo signal. | ||
| CH3 | PWMUsually throttle. | ||
| CH4 | PWMChannel 4 servo signal. | ||
| CH5 | PWMChannel 5 servo signal. | ||
| CH6 | PWMChannel 6 servo signal. | ||
| IBUS | serial TXAll channels as serial data (115200 baud) to the board's RX. | ||
| + | 5 V4.0-6.5 V, usually from the ESC BEC. | ||
| - | ground |
Size and material
- Size
- 174 × 190 × 92 mm
- Material
- plastic
- Sold by the
- set
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
