1-channel 5 V relay module (optocoupled)
An electric switch your board can flip to turn a pump, light or motor on and off.
Songle 5 V relay on a board with optocoupler, transistor driver, flyback diode and LEDs. High/low trigger jumper. Contacts rated 10 A 250 VAC / 10 A 30 VDC. Coil draws about 70 mA from VCC; IN draws a few mA and works from 3.3 V logic.
Electrical
- Supply voltage
- 4.5 to 5.5 V
- Current
- 72 mA typical, 90 mA max
- Talks over
- digital
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| VCC | 5 VLabelled DC+ on most boards. | ||
| GND | groundLabelled DC-. | ||
| IN | digitalTrigger input. Set the jumper for HIGH or LOW trigger. | ||
| COM | not connectedSwitch common (screw terminal). | ||
| NO | not connectedClosed to COM while the relay is on (screw terminal). | ||
| NC | not connectedClosed to COM while the relay is off (screw terminal). |
Size and material
- Size
- 50 × 19 × 26 mm
- Material
- pcb
- Sold by the
- piece
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.