2-channel 5 V relay module (optocoupled, low-level trigger)
Two electric switches your board can flip, for two separate pumps, lights or motors.
Two relays on an optocoupled driver board with status LEDs and a JD-VCC jumper. Each input draws 15-20 mA and is active LOW. Contacts rated 10 A 250 VAC / 10 A 30 VDC. 50.5 x 38.5 x 18.5 mm.
Electrical
- Supply voltage
- 4.5 to 5.5 V
- Talks over
- digital
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| VCC | 5 V | ||
| GND | ground | ||
| IN1 | digitalChannel 1, active LOW. | ||
| IN2 | digitalChannel 2, active LOW. | ||
| COM1 | not connected | ||
| NO1 | not connected | ||
| NC1 | not connected | ||
| COM2 | not connected | ||
| NO2 | not connected | ||
| NC2 | not connected |
Size and material
- Size
- 51 × 19 × 39 mm
- Material
- pcb
- Sold by the
- piece
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.