8-channel 5 V relay module (optocoupled, active-low)
8 electric switches on one board, for controlling several pumps, lights or valves.
8 relays on an optocoupled board, each with a status LED and NO/COM/NC terminals; inputs are active LOW. JD-VCC jumper lets the relay coils run from a separate 5 V supply. Contacts rated 10 A 250 VAC. With all 8 relays on, the coils draw far more than a board's 5 V pin should supply.
Electrical
- Supply voltage
- 4.5 to 5.5 V
- Talks over
- digital
Needs alongside it
- Power from a supply rated for about 70 mA per active relay coil (a typical 5 V relay), not the board's 5 V pin. Join the grounds.
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| VCC | 5 VLogic / optocoupler supply. | ||
| GND | ground | ||
| JD-VCC | 5 VRelay coil supply. Remove the jumper and feed a separate 5 V supply for isolation. | ||
| IN1 | digitalChannel 1, active LOW. | ||
| IN2 | digitalChannel 2, active LOW. | ||
| IN3 | digitalChannel 3, active LOW. | ||
| IN4 | digitalChannel 4, active LOW. | ||
| IN5 | digitalChannel 5, active LOW. | ||
| IN6 | digitalChannel 6, active LOW. | ||
| IN7 | digitalChannel 7, active LOW. | ||
| IN8 | digitalChannel 8, active LOW. | ||
| COM1 | not connected | ||
| NO1 | not connected | ||
| NC1 | not connected | ||
| COM2 | not connected | ||
| NO2 | not connected | ||
| NC2 | not connected | ||
| COM3 | not connected | ||
| NO3 | not connected | ||
| NC3 | not connected | ||
| COM4 | not connected | ||
| NO4 | not connected | ||
| NC4 | not connected | ||
| COM5 | not connected | ||
| NO5 | not connected | ||
| NC5 | not connected | ||
| COM6 | not connected | ||
| NO6 | not connected | ||
| NC6 | not connected | ||
| COM7 | not connected | ||
| NO7 | not connected | ||
| NC7 | not connected | ||
| COM8 | not connected | ||
| NO8 | not connected | ||
| NC8 | not connected |
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.