KY-040 rotary encoder module
A knob that clicks as it turns and can be pressed, for scrolling through menus.
20-detent incremental encoder with push switch, on a board with 10 kΩ pull-ups on CLK and DT. Turning produces quadrature pulses; pressing the shaft closes SW to GND (no pull-up fitted on SW). 3.3-5 V.
Electrical
- Supply voltage
- 3.3 to 5 V
- Talks over
- digital
Needs alongside it
- SW has no pull-up on the module: enable INPUT_PULLUP on that pin.
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| CLK | digitalOutput A. Pulled up to + on the board. | ||
| DT | digitalOutput B. | ||
| SW | digitalPush switch to GND. Needs INPUT_PULLUP. | ||
| + | 3.3 V, 5 VUse the board's logic voltage. | ||
| GND | ground |
Size and material
- Size
- 18 × 28 × 32 mm
- Material
- metal
- Sold by the
- piece
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.