MAX485 RS-485 transceiver module (5 V)
Sends serial data down long cables between buildings or across a field.
TTL-to-RS-485 half-duplex transceiver on a 44 x 14 mm board with a 5.08 mm A/B terminal. Long, noise-proof serial links (hundreds of metres) to Modbus sensors, VFDs and remote boards. 5 V supply; RO outputs 5 V, so shift it down for 3.3 V boards. DE and RE set transmit/receive.
Electrical
- Supply voltage
- 4.75 to 5.25 V
- Logic level
- 5 V
- Talks over
- uart, digital
Needs alongside it
- RO swings to 5 V: use a divider or level shifter into a 3.3 V board's RX.
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| RO | serial TXReceiver output (5 V), to the board's RX. | ||
| RE | digitalReceiver enable, active LOW. Tie to DE. | ||
| DE | digitalDriver enable, HIGH to transmit. | ||
| DI | serial RXDriver input, from the board's TX. | ||
| VCC | 5 V | ||
| GND | ground | ||
| A | not connectedRS-485 A (+), on the 5.08 mm screw terminal. | ||
| B | not connectedRS-485 B (-), on the 5.08 mm screw terminal. |
Size and material
- Size
- 44 × 10 × 14 mm
- Material
- pcb
- Sold by the
- piece
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.