Skip to content

Parallax Feedback 360° high-speed continuous servo

Report component

Tell our team what needs attention. You must be signed in to send a report.

Up to 2,000 characters. Include what the team should check.

A wheel motor that also tells the board exactly where it is, for robots that steer precisely.

Continuous-rotation servo with a Hall-effect position sensor: a 910 Hz feedback signal (2.7-97.1 % duty) reports the exact shaft angle. Up to 140 rpm at 6 V, 2.2 kg·cm stall. 5-8.4 V (5.8-8 V recommended); 15 mA idle, 150 mA no-load, 1.2 A stalled. 50.4 x 37.2 x 20 mm with tabs (mounting holes 10 x 49.5 mm), 40 g.

Electrical

Supply voltage
5 to 8.4 V
Current
150 mA typical, 1200 mA max
Talks over
pwm

Needs alongside it

  • Power from a supply rated for 1.2 A per servo at 6 V, not the board's 5 V pin. Join the grounds.

Pins

PinCan doMax VMax mA
GNDgroundBrown or black wire.
V+5 V, power inRed wire.
SIGPWMOrange, yellow or white wire. 1280-1720 µs at 50 Hz (1500 = stop).
FBdigitalYellow feedback wire: 3.3 V PWM at 910 Hz; duty cycle encodes the angle.

Size and material

Size
55 × 37 × 20 mm
Weight
40 g
Material
plastic
Sold by the
piece

Works with

Projects using it

No public project uses it yet. Design one that does.