Universal USB / DC / solar Li-ion charger (bq24074)
Charges the project's battery from the sun or a USB charger, and runs the project at the same time.
Charges a single 3.7 V Li-ion/LiPo from USB-C, a DC jack or a 5-10 V solar panel (28 V protected), at 0.5, 1 or 1.5 A by jumper. Power-path load output (OUT, 3-4.4 V) keeps the project running while charging. CHG and PGOOD status pins.
- Charges lithium batteries. Designs using it get a safety review before we build them.
Electrical
- Supply voltage
- 4.4 to 10 V
- Talks over
- power, digital
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| VBUS | power in, 5 VInput rail from the USB / DC jack (where the solar panel plugs in). | ||
| OUT | batteryLoad output, 3.0-4.4 V, also on the 'Load Out' JST-PH jack. Feed a boost or 3.3 V regulator from here. | ||
| LIPO | batteryBattery + (same as the JST-PH battery port). | ||
| GND | ground | ||
| CHG | digitalLOW while charging (open drain). | ||
| PGOOD | digitalLOW when input power is good (open drain). | ||
| CE | digitalPull HIGH to stop charging. |
Size and material
- Size
- 36 × 8 × 27 mm
- Material
- pcb
- Sold by the
- piece
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
Projects using it
No public project uses it yet. Design one that does.