2.9" e-paper display, 296x128 (SPI)
A paper-like screen that stays readable in daylight and only uses power when it changes.
Black and white e-paper module (Waveshare), SPI, 296x128. Keeps its image with the power off; full refresh about 3 s (partial refresh supported). Runs on 3.3 V or 5 V. 26.4 mW while refreshing, under 0.01 µA standby. 89.5 x 38 mm.
Electrical
- Supply voltage
- 3.3 to 5 V
- Logic level
- 3.3 V
- Current
- 8 mA typical, 20 mA max
- Talks over
- spi, digital
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| VCC | 3.3 V, 5 V | ||
| GND | ground | ||
| DIN | SPI MOSI | ||
| CLK | SPI clock | ||
| CS | SPI select | ||
| DC | digitalData / command select. | ||
| RST | digitalReset, active LOW. | ||
| BUSY | digitalHIGH while the panel is refreshing. |
Size and material
- Size
- 90 × 1 × 38 mm
- Material
- screen
- Sold by the
- piece
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W
