SSD1306 0.96" OLED, 128x64, I2C
A tiny, sharp screen that shows text, numbers and simple graphics.
Monochrome 128x64 OLED (white or blue/yellow) on a 4-pin I2C module with its own regulator. Address 0x3C (0x3D via the back resistor). 3.3-5 V, about 20 mA with typical content. Pixels dim after ~1000 h fully lit, so use a screensaver.
Electrical
- Supply voltage
- 3.3 to 5 V
- Logic level
- 3.3 V
- Current
- 20 mA typical, 30 mA max
- Talks over
- i2c
- I2C address
- 0x3C, 0x3D
Pins
| Pin | Can do | Max V | Max mA |
|---|---|---|---|
| GND | ground | ||
| VCC | 3.3 V, 5 VIts I2C pull-ups go to VCC: power it from 3.3 V on 3.3 V boards. | ||
| SCL | I2C clock | ||
| SDA | I2C data |
Size and material
- Size
- 28 × 11 × 27 mm
- Material
- screen
- Sold by the
- piece
Works with
- Arduino Uno R3
- Arduino Nano
- Arduino Mega 2560 Rev3
- Arduino UNO R4 WiFi
- Arduino UNO R4 Minima
- Arduino Nano ESP32
- ESP32 DevKitC (ESP32-WROOM-32, 38-pin)
- ESP32-S3-DevKitC-1 (N8R8)
- Adafruit ESP32-S3 Feather (4 MB flash, 2 MB PSRAM)
- Seeed XIAO ESP32S3 Sense (camera + mic)
- Seeed XIAO ESP32C3
- Seeed XIAO ESP32C6
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040, Wi-Fi)
- Raspberry Pi Pico 2 (RP2350)
- Raspberry Pi Pico 2 W (RP2350, Wi-Fi)
- Seeed XIAO RP2040
- Seeed XIAO nRF52840 (Bluetooth LE)
- Raspberry Pi 5 (4 GB)
- Raspberry Pi 4 Model B (4 GB)
- Raspberry Pi Zero 2 W

